Steps for Remount raided drives after changing g-raid

Changing the RAID configuration on your G-RAID device — whether it's from RAID 0 to RAID 1, JBOD, or another setup — can sometimes result in drives not mounting properly or showing up as uninitialized. Remounting them requires a careful approach to avoid data loss and restore proper functionality.

Below are the key steps and considerations to remount your RAIDed drives after reconfiguring your G-RAID device.

Important: Backup Before You Change RAID Configuration

Before diving into the fix, understand that changing the RAID mode erases all existing data unless you're using a model with configurable RAID without formatting (some high-end G-RAID units support this). If you haven’t already backed up, do not proceed further, and consider using data recovery software or consulting a professional.

Step 1: Power Cycle the Device and Check Connections

Turn off the G-RAID.

Disconnect all cables (USB, Thunderbolt, power).

Wait 10 seconds and reconnect everything.

Power on the unit and wait for the drives to spin up fully.

Sometimes a clean reboot after reconfiguration helps the system recognize the RAID set correctly.

✅ Step 2: Install G-RAID Utility and Drivers

Visit the official Western Digital (G-Technology) website and install the G-RAID Configurator Utility for your device model. It allows you to:

Verify RAID mode

Rebuild or initialize drives

Monitor drive health

Ensure all drivers and firmware are up to date, especially on macOS or Windows 11 systems, which may restrict mounting of unverified volumes.

Step 3: Check Disk Utility (macOS) or Disk Management (Windows)

On macOS:

Open Disk Utility.

Look for the G-RAID volume.

If it appears but is grayed out, click Mount.

If it asks to initialize, stop — it means the system can’t recognize the RAID volume (possibly due to formatting differences).

On Windows:

Open Disk Management.

Right-click the G-RAID volume and select Online or Change Drive Letter and Paths.

Avoid initializing the disk if prompted unless you're setting up a new RAID.

✅ Step 4: Use Terminal (macOS) or Diskpart (Windows) for Advanced Mounting

If standard tools fail:

On macOS:

Open Terminal and type:

Identify your G-RAID volume and use:

On Windows:

Open Command Prompt as Administrator.

Type diskpart > list disk > select disk X > online.

Step 5: Rebuild or Reformat if Required

If the new RAID configuration was intentional and no data needs to be preserved:

Use the G-RAID utility to format the volume.

Choose a file system compatible with your OS (exFAT for cross-platform, HFS+ for macOS, NTFS for Windows).

After formatting, the drive should automatically mount.

Conclusion

Remounting a G-RAID after a RAID change involves verifying connections, using manufacturer utilities, and sometimes performing a reformat. If your data is critical and wasn’t backed up, stop and consult a recovery professional before making changes. With the right tools and precautions, you can restore RAID functionality safely.